DJI WKM XAIRCRAFT KK K6300S ETC SUPPORTED AKE HighSPEED PWM 12A ESC:
AKE HighSPEED PWM series ESC is specially dedicated to the development of multi-axis high-speed aircraft ESC, support 2ms pulse width control, with up to 500Hz refresh rate, precision and agility to respond to control signals issued by the flight control with to excellent speed linear, smooth and delicate touch; high-performance power MOSFET with low resistance, low heat, high efficiency, with optimization for multi-axis control aircraft brushless motor control algorithms, to bring accurate , agile, reliable, excellent performance brushless motor, so that multi-axis aircraft flying more stable and reliable control feel more desirable.
This paragraph AKE HSP Series 12A brushless ESC is very suitable for conversion XAircraft X650V4 or X650V8, ESC can be mounted directly to the original position on the rack, wire length is also very suitable, do not change cables, or add more cables. Perfect support DJI WKM flight control and flight control XAircraft FC1212-S. Built-2A linear BEC, fully meet the requirements DJI WKM (WKM requirements BEC power supply capacity> 1A, otherwise system will be unstable), this esc has been tested and do not have extra access BEC.
- High-speed CPU, supports up to 2ms pulse width control, with up to 500Hz refresh rate, linked to the governor to bring a very linear, smooth and delicate touch;
- Super compatibility with the market and the vast majority of all flight control remote control (such as DJI full range, XAircraft FC1212-S, KK, etc.)
- Multi-axis controller algorithm for the optimization of aircraft;
- Ultra-low-impedance PCB, is highly resistant to current capacity;
- With abnormal input voltage / low voltage battery protection / overheat protection / throttle signal lost protection, multiple protection, effectively extending the life of the ESC;
- A common start / soft start / super soft and start three startup modes for multi-axis aircraft, helicopters and fixed-wing aircraft;
- With a throttle correction, so that more simultaneous multi-axis control.
User Note 1: When the system is installed more than one pc ESC, please keep only one of a power transfer signal cable circuit is in leading through state., the rest ESC red signal cable are disconnected, the way can improve ESC inner BEC working efficiency, and also can avoid unnecessary power consumption.
xaircraft or other multi axis aircraft power convert cable T plug male to JST male x 6
A.E.K HighSPEED PWM ESC 12A Specifications
Battery: 2S ~ 4S lithium polymer battery
Maximum continuous current: 12A
Current capacity: 15A
BEC: 5V/2A linear mode
Size: 32mm x 18mm x 10mm
Weight: 13.4g (including wire)
Input: JST Female (length 215mm)
Signal lines: JR Male (length 365mm)
Output plug: 2.0mm female banana plug (length 20mm)
Notice: AKE HSP-12A ESC had built-in 2A linear BEC, completely eliminate the ripple interference when BEC switch, other most common ESC's BEC only 1A output capability, it may cause DJI WKM performance degradation ,sometimes caused DJI WKM out of control, this is top important point !!